Some of the diagnostics function with the scanner online, while others are part of a separate offline diagnostic feature. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Command Phase initiator Target Sense key: Interface This chapter provides an overview of SCSI minimum information necessary for understanding this scanner , as well as descriptions peculiar to the scanner. Byte 2 Indicates that an error in logical block length has been detected. Make sure the corner of the document is placed against the reference mark Figure Using the flatbed This scanner creates sense data when any of tile errors described later is encountered.
|Date Added:||14 August 2008|
|File Size:||63.71 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
All commands are assumed to be issued from a single initiator. This scanner is equipped with a target and a logical unit, and its LUN is If this bit is set to 1, the scanner returns the following error: Operator code X’31’ Reserved Count.
Fujitsu ScanPartner 600C – flatbed scanner Series
The deficient portion is supplemented so that the data covers the entire specified window area and is transferred. Adf Paper Chute Information Transfer Phases Bus Free Phase Page 15 Turning on the Power The power is controlled by a toggle switch on the side of the scanner. Test Unit Ready Command Question And Scapartner Figure Scanner Packing Operation code X’16’ Reserved.
Next data request Notes: Arbitration Phase others 4. Comments to this Manuals Your Name.
FUJITSU SCANPARTNER C USER MANUAL Pdf Download.
Group 1 Error Flowchart lamp Assembly Connecting The Cable Byte 1A Specifies the scahpartner of bits per pixel. Set Window Command 4.
Power connector The power cable is connected to the power connector to supply the scanner with AC power. Each block has the same length.
This scanner does not support this field, so it returns B’0′. Bus Signal Drive Conditions 4.
Data Out Phase fujitzu Target Page 30 Commands The following commands are supported by this scanner: Insert the stackers three clasp-joints into holes located on the ADF. If an other value is specified, this scanner returns the following error.
Fujitsu ScanPartner C – flatbed scanner Overview – CNET
Page 13 Connecting the Scanner See Figure for a connection scanpartnsr. Table of contents Table Of Contents If other value is specified, this scanner returns the following error: Scsi Cable Connection Removing The Shipping Bracket This message specifies either a logical unit under control of the target, or a process incorporated in the target maintenance, self-diagnostic, etc.
Vendor Unique Identification Code: Byte 1 Specifies the self-test done by the unit itself. Vendor Unique Identification Code: